I have binned my ABS on my mk3 so was wondering what setup do I need to run so my brakes work fine without the ABS. Will I need a brake proportioning valve etc? Thanks
ive been thinking about this. remove the abs unit under the bonnet, get a series of flexi hoses to reconnect the relevant hard lines with a bias valve for the rear.
Could do that but my car needs new Brake lines so I was up for making a whole new setup, bias valves would also work but there are two lines going to the rear of the car so you would need two bias valves right?
well been the scene fag i am i have binned the abs module because i have a shaved engine bay pricing up some braided hoses and bias valve so will see if its any good.
Can I use the abs module as a bias valve? I've Swapped a mk3 vr6 beam into a mk2 and lost the proportioning valve. Looking to go abs later, once I get a loom.
yes so long as you have the correct version of abs, the system takes over the function of the bias valve which is why some mk3 with abs have no valve