Hammerite Stone Shield?.

Discussion in 'Styling, Trim and Bodywork' started by KeithMac, Jul 13, 2018.

  1. KeithMac Forum Junkie

    Joined:
    Oct 27, 2003
    Likes Received:
    140
    Location:
    Kazakhstan
    Hello all, I'll be taking wishbones/ rear beam/ engine front and rear cross members etc off and wire cup/ bead blasting.

    I was planning on powdercoating the lot but to be honest I did the rear beam and it didn't take long to chip and rust..

    Looking at the Hammerite Stone Shield now but I don't want a paint that will smudge when handled?.

    Anyone had any experience with it?.

    I've read good reports with POR15 but is that a 2 pack paint?.

    Can anyone recommend a decent rust treatment, will be hopefully removing all of it but belt and braces..

    Any input welcome!.

    Cheers, Keith.

    ham7212690m.jpg
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice