I'm looking for someone who can build up my 16v race spec engine. I could probably do it myself if I put my mind to it but after spending a lot on all the right parts I'd rather find someone with prior experience/knowledge of such builds. I have most of the parts ready to assemble Inc all new gaskets, fittings, etc and machined/lightened/balanced parts by Hotgolf.. Brief spec as follows.. 9A bottom end bored out to accept wossners knife edged/balanced crank lightended intermediate shaft wossner high compression forged pistons INA H beam rods ARP head studs All new bearings, etc New baffled sump Neuspeed windage tray (need exhaust manifold) ABF cylinder head Ported & polished Injector ports tig welded up for ITB's 3 angle valve job Machined for clearance of high comp pistons New hydraulic lifters & valves Newman 272 cams (unsure at this stage whether to use these cams or go for something wilder with solid lifters.. Engine is going into a wide tracked Mk1 Golf track car) New 45mm throttle bodies (need inlet manifold) Omex engine management system & wiring loom .. I'm based in Lancashire so someone local would be ideal but I'm open to suggestions. Anyone recommend someone who can make a good job of building this sort of thing? A bit of cash for the new year!! Thanks
Me too , my engine was built by him , and is 249hp with good torque from low down , it goes very well
Thanks for all the replies. I've spoken to Jason now and had a good chat.. nice guy. I hope to get it on with in the new year but probably going to go with a solid lifter head and wilder cams to his spec.