Ive got a mk1 clipper cab ive uprated the fuel system,brakes,suspension etc and im almost ready to start fitting the ABF motor. id like to run the DTH bodies, could you give me a rundown of the parts ill need. i have a modified ABF ECU with modified mk1 loom, i will be using the existing crank sensor and most likely ford edis (or possibly a modified dizzy cap from a pug) i have a 1.8T fuel rail if thats any use? any advice would be greatly appreciated
so you are saying you have management system sorted by your proposed abf ecu and edis etc... bodies themselves are - 549/pair fuel rail - 48 Throttle mechanism to use std VW cable - 98 airhorns 45x120 - 27.60/each throttle pot - 49.90 throttle pot electrical connector - 10.56 Above prices are exv vat, but I can offer 15% discount so effectively these are inc vat prices if that makes sense. delivery is 12 regards
sorry,bit of a last minute of lunchtime post there yes i have managment sorted..thanks for the prices
yes... but usually a hall sender not reluctor sender so you need to swap that out for most aftermarket ecu's