hi all ive got a 4 ch stereo with a 4 ch amp powering 4 6*9s, ive also got a mono block runnin on a high input (ie speaker channels not rca) powering a 12 inch sub. was lookin at gettin a stereo with three sets of rca's anyone know of one or if they exist cause im using the speaker ch for the sub and would like to use them for components.
A lot of the top ends units tend to have 3 RCA outs - normally a front, rear and sub ---- all do the same thing but on some you have the ability to fade the sub RCA. (http://www.pioneer.co.uk/uk/product_detail.jsp?product_id=3 988&taxonomy_id=25-121) Some other manufacturers will do them on cheaper units like Kenwood etc but if it aint Alpine or Pioneer as far as headunits go I dont rate em (oh and Nakamichi!) Failing that you can use RCA splitters
4 6x9s If you must then why don't you run the 6x9s off the headunit speaker channels. Which leaves 2 sets of pre-outs. 1 set of pre-outs for your sub 2nd set can be used for your components. You could also amp 1 set of 6x9s if need be, by using RCA Splitters. IMO i would ditch the 6x9s and put it towards some decent cabling??? Prax
