Building a 16v turbo what parts

What would you need to build a 16v turbo

 

do you already have a valver?

 

16v block-low comp pistons
intercooler from a gtd or similar
oil feed
custom downpipe
turbo

Edited by: CabrioRags

 

not forgeting a manifold.

 

is it possible to use a tdi manifold

 

i'm not 100% sure but i think that can only be used on an 8v head.

 

turbo site

this aint a bad site

 

check this site out altern8 it has turbo manifolds for
garret turbos.hows your german? check this
Edited by: stealthwagon

 

id buy a manifold from ATP Turbo and a Garrett T28.

Some decent injectors and G60 management.

Decent charge cooler or Rallye IC for factory look.

JE low comp pistons

Ridgeway Racing pistons

and enjoy 320bhp

 

abf block, kr head, 2e pistons, g60 management, rs2 exhaust manifold, rs2 inlet manifold

 

The words from someone that sounds like they've already built one??

 

you can get turbo manifold of the vwvortex forum... Around about $300 which is about 170 which isent bad.

Wot compresstion ratio does it have to run at?

Vduber

 

mine has been lowered to 8:5.1 by offset bushing of the small ends of the conrods.

 

How do you get around the crank case breather?

 

RS2 engines are 5 cylinder? Shorten the inlet yep, not the exhaust it would never fit.......It would also be better to use 20v pistons from the late ur-quattros or S2 as these will have the cuts for valves in the top of the pistons and give the 8.5.1 comp required

 

siezure ABF breather is just like a KR one

s2 pistons are ideal but 500

 

what capacity to s2 pistons give?

 

The 20v quattro/S2/RS2 pistons are available in 81.01mm, 81.26mm and 81.51mm from Kolbenschmidt the cost 80 each....

 

so in an abf block to keep the 2l i'd need?

 

You will have probs. as the ABF has a 82.5mm bore and a 92.8 stroke so the S2 pistons would be no good...